position error

基本解释

In this paper, author studies the position error-compensating control problem of cutting process by using the classical control theory.
本文作者运用经典控制论对切削过程的位置误差补偿控制进行了研究。
Position prediction algorithm is introduced to compensate the position error in the sampling time, or the extra torque ripple would be produced.
针对采样周斯内的位置误差会引起电机额外的转矩波动，本文引入了位置预测算法。
Then discuss the rotor position error caused by armature reaction, calculate the phase angle, and brought forward the compensation measures.
然后对由电机电枢反应所引起的转子位置误差进行了分析，计算了位移角的大小，提出补偿策略。

It was one of only two known watches Patek Philippe made in platinum with a complex tourbillon movement--the word means "whirlwind" in French--that continually adjusts for error when the watch's position shifts.
FORBES: Inherit the whirlwind
In the aftermath of the big trading error, Knight also said it would create a board-level risk committee and a chief risk officer position.
FORBES: Getco Gets NYSE Listing Via Reverse Merger With Knight Capital

位置误差
Based on all above, I design a useful circuit to distill the position error and a single-chip computer control circuit.
在此基础上,设计了实用的位置误差提取电路和单片机控制电路。
定位误差
In point-to-point motion experiments, stable position error is less than 5 microns with no overshoot.2. The point-to-point motion is divided into two stages, one is the high-speed motion and the other is the high-precision positioning.
在点到点运动实验中,稳态定位误差小于5μm,且响应无超调。
四角误差

位置误差
定位误差
位置偏差
The algorithm has two traits relative to the traditional approach: the position of the corners can be determined automatically while not requiring manual interposition, and high precision could be acquired and the mean position error is below 0.1 pixels.
与传统方法相比，该算法具有两个明显的优点：无须人工干预，能够自动确定角点位置；定位精度高，角点的平均位置偏差在0.1个像素以内。
位置错误

位置误差
定位误差
Due to the inherent hysteretic nonlinearity,the giant magnetostrictive actuator(GMA)can cause position error in the open-loop systems,and cause instability in the closed-loop systems.
由于内在的滞回非线性,超磁致伸缩驱动器(GMA)会在开环系统中引起定位误差,在闭环系统中造成系统不稳定。
位姿误差